3.6.4 Adjusting the throat plate
General
For cleaning the throat plate, it can be removed after loosening the
screws 1 and 2, without causing any adjustment changes.
The adjusting washers under the screws 3 and 4 will again position the
throat plate.
Rule and control
The needle should stitch in the middle of the stitch hole.
–
Lower the sewing head by the function "
Lifting/lowering the
sewing head
".
–
Press the key "
O
".
"Safe motor stop" will be switched on.
Caution: Danger of bodily injuries !
The machine must be in the "Safe motor stop" position
.
Correction
–
Loosen the screws 1, 2, 3 and 4.
–
Adjust the throat plate 5.
–
Tighten the screws 1, 2, 3 and 4.
1
2
3
4
5
52
To Next Page
Loading...
