4.3.2 Adjustment range of the rear setting wheel
The position of the setting wheel 1 determines the "Folding position" of
the middle slide in its rear section. The "Folding position" in the "front"
section depends on the position of the setting wheel 4.
Caution: Danger of bodily injuries !
Do not introduce your hands into the area of the moving machine parts.
Rule and control
It should be possible to move the lateral slides 5 under the middle
slide at the smallest distance possible when the two settings wheels 1
and 4 are in "0" position and the inner frame 4 stands in the "folding
position".
The adjustment range of the setting wheel 4 must be correct.
–
Select the "
Single step mode
" function.
–
Turn both setting wheels into "
0
" position.
–
Repeat pressing the "
Start
" key until the inner frame stands in the
folding position and the lateral slide can be advance by hand.
Correction
–
Changing the position of the stop screws 3.
Make sure that the levers 2 are resting on both stop screws 3.
1
2
3
4
5
73
To Next Page
Loading...
