DURKOPP ADLER 806 - Horizontal Position of the Throat Plate

2.2.5 Horizontal position of the throat plate
Caution: Danger of bodily injuries !
The machine must be in the position "Safe motor stop ".
Rule and control
–
In X-direction:
In the loop formation position – or a bit later – the needle shank 2
should be distanced 0.3 mm from the right side of the stitch hole 1.
–
In Y-direction:
In this direction, the needle should stitch in the middle of the stitch
hole.
Correction
–
Lower the sewing head by the function "
Lifting/lowering the
sewing head
".
–
Press the key "
O
".
"Safe motor stop " will be switched on.
–
Loosen the screws in the bore-hole 3 and 5 and change the
position of the throat plate 4 accordingly.
–
Retighten the screws in the bore-holes 3 and 5.
1
2
3
4
5
12