2.8 Lifting the thread tensioner
The thread tensioner will be lifted during the cutting process or after
pressing the button 3 on the supporting plate.
Caution: Danger of bodily injuries !
Turn off the main switch.
Switch off the machine before adjusting the lifting of the thread
tensioner.
Rule and control
The thread must pass freely through the lifted tensioner during the
cutting process..
–
By means of the traction rod 1, lift the thread tensioner as far as
possible.
Correction
–
Loosen the screw 1.
–
Change the position of the traction rod 2 accordingly.
–
Tighten the screw 1.
1
2
3
25
To Next Page
Loading...
