DURKOPP ADLER 806 - Timing the Operation of the Switches

4.3.6 Timing the operation of the switches
Caution: Danger of bodily injuries !
Do not introduce your hands into the area of the moving machine parts.
Rule and control
The switches should release signals at the following moments:
S15 Operation of the signal when the middle slide is
about 80 mm from the rear end position
S12 Release of the switch in the front position of the
Middle slide
S11 Operation of the switch in the lower position of the
Middle slide
S10 Operation of the switch in the "Folding position of the
middle slide"
–
When switching on, hold the key "
F3
" pressed down.
–
Select the "
switch checking
" function.
–
Displace the middle slide by hand until all switches are released.
The switch names will be displayed.
Correction
–
Loosen the clamping screw of the switch.
–
Reset the switch position accordingly.
–
Retighten the switch clamping screw.
S11
S12
S10
S15
77