DURKOPP ADLER 806 - 2 Machine Head (Class 806-111); Stitch Regulator and Transmission Lever; 0-Position of the Stitch Regulator

2. Machine head (Class 806-111)
2.1 Stitch regulator and transmission lever
2.1.1 0-position of the stitch regulator
Caution: Danger of bodily injuries !
The machine must be in the position "Safe motor stop " .
Rule and control
The needle bar should not ”oscillate” when sewing without zigzag
function.
–
Lower the sewing head by the function "
Lifting/lowering the
sewing head ".
–
Press the key "
O
".
"Safe motor stop” will be switched on.
–
Unscrew oil pan cover.
–
Introduce hexagon screw screwdriver into the screw 1.
–
Turn the setting wheel of the stitch regulator until the spanner
moves as little as possible..
Correction
–
Loosen counter nut 3.
–
Turn screw 2 accordingly.
–
Tighten counter-nut 3.
3
1
2
6