DURKOPP ADLER 806 - Timing the Action of the Switches

115 pages

To Next Page

To Previous Page

4.1.3 Timing the operation of the switches

Rule and control

The switches S3, S6 and S8 should be operated short before the end

position of the outer frame.

–

When switching on, hold the key "

" pressed down.

–

Select the function "

Checking the input elements

–

Move the outer frame by hand.

The display will show the circuit state of the input element, the

state of which has changed.

Check whether the following switches are releasing:

S3 outer frame, rear

S6 outer frame, top

S8 outer frame, bottom

Correction

–

Loosen the clamping screw of the switch to be changed.

–

Change the position of the switch.

–

Tighten the clamping screw of the switch.

Other manuals for DURKOPP ADLER 806