2.10 Lubrication
2.10.1 General information
–
The wicks used for the lubrication of the respective elements in the
machine head should not touch the re-circulation wick.
–
The plastic cap on the hook impedes the suction of dust and fluff
into the hook case by the vacuum pump.
–
The oil splash screw 22 ensures that enough oil is supplied to the
collecting sheet even if the oil level is very low..
–
When completing the machine or following a longer machine stop,
lubricate the ”dried up” wicks before restarting the machine,
because an insufficient lubrication can cause damages.
–
The slotted screw 24 under the lubrication adjustment screw 23
can be turned out, so that any obstructions of the oil ducts in the
hook race can be eliminated by a blowing gun.
Turn-in the screw 24 completely.
23
24
22
1 2 3 4 5 6 7 8
14 13 12 11 10 9
18 19 20 21
17
16
15
27
To Next Page
Loading...
