DURKOPP ADLER 806 - Thread Take-Up Spring

2.7 Thread take-up spring
Caution: Risk of Injury !
The machine must be in the position "Secured stop of motors".
Rule and control
Adjust the travel and the tension of the thread take-up spring in a way
that at the moment when the spring reaches its lowest position, the
eye of the stitching needle is disappearing in the fabric.
–
Lower the sewing head by the function "
Lifting/lowering the
sewing head
".
–
Select the "
speed
" function.
–
Enter the value 70 by the numerical keys and confirm by the
RETURN
key.
–
Press key "
F2
" for starting the sewing process.
–
Watch the thread take-up spring.
–
Press key "
F3
" for stopping the sewing machine head.
Correcting the travel
–
Loosen slightly the screw 2 on the arm 1 by using a hexagonal
screw spanner.
–
By means of the bolt 1, turn the entire thread tension unit
accordingly.
–
Tighten screw 2.
Correcting the tension
–
Press the key "
O
".
"Safe motor stop " will be switched on.
–
Loosen the screw 2 on the arm 1.
–
Pull out the thread tension unit.
–
Loosen the screw 4.
–
Turn the bolt 3 accordingly.
–
Tighten the screw 4.
–
Replace the thread tension unit.
–
Tighten the screw 2.
1
2
3 4
24