DURKOPP ADLER 806 - General Information; Position of the Entered Corner Introduction Slide

4.5.2 General information
–
The purpose of the corner slide 6 is to place the fabric under the
30°-edge of the lateral slide 5, in order to avoid any fabric
projection in the pocket opening area.
–
In case of corner introduction slides for the class 806-111 attention
must be paid to the prescribed swivel position.
Double seam: pin in the bore-hole 2 for a longer stroke
Single seam: pin in the bore-hole 1 for a shorter stroke
4.5.3 Position of the entered corner introduction knife
Caution: Danger of bodily injuries !
Do not introduce your hands into the area of the moving machine parts.
Rule and control
The amount of overlapping between the entered corner introduction
slide 6 and the lateral slide sheet 5 should range between 1 and 2 mm
, depending on the fabric type.
–
Select the "
Single step mode
" function.
–
Operate the "
Start
" key accordingly.
Correction
–
Loosen the screw 3 and the screw 4.
–
Change the position of the corner introduction slide 6 along the
arrow direction accordingly.
–
Tighten the screw 3 and the screw 4.
1
2
3
4
5
6
80