DURKOPP ADLER 806 - Corner Slide; Position of the Folding Edge of the Lateral Slide

4.5 Corner slide
4.5.1 Position of the "fold edge" of the lateral slide
Caution: Danger of bodily injuries !
Do not introduce your hands into the area of the moving machine parts.
Rule and control
Following the "corner introduction" the position of the cut part should
be as shown in the illustration at the right top.
–
Call up the "
Single step mode
" function.
–
Position the cut pocket part on the middle slide.
–
Repeat pressing the "
Start
" key until the lateral slides are
depressurised.
–
Displace lateral slides in "y" direction by hand.
–
Adjust the height (y-direction) of the lateral slides by the sheet
strip, contained in the accessories.
Correction
–
Loosen all screws 4.
–
Change the position of the lateral slide sheet 1 accordingly.
–
Tighten all screws 4.
4
1 2 3
79