2.12.2 Lateral position of the thread pulling knife
Rule and control
–
The thread pulling knife 2 should travel along the bobbin case
lug 1 at a safe distance.
–
The thread pulling knife 2 should not knock against the bobbin
case 3.
Caution: Danger of bodily injuries !
The machine must be in the position "Safe motor stop ".
Correction
–
Lower the sewing head by the function "
Lowering/lifting the
sewing head
".
–
Press the key "
O
".
"Safe motor stop " will be switched on.
–
Loosen the screw 4.
–
Change the position of the thread pulling knife 2 accordingly.
–
Tighten the screws 4.
1
2
3
4
34
To Next Page
Loading...
