11. Error messages
11.1 Control error messages
Error number Explanation Remedy
100 Undervoltage Stablize power supply
101 - 199 Processor error ---
TRANSFER STOP Safety switch of the transfer plate has been
triggered
see chapter 4.2 of the
Operating Instructions
EMERGENCY STOP Emergency switch has been triggered see chapter 4.2 of the
Operating Instructions
MP GP The basic adjustments of the 806 have been lost see chapter 10.2 and
chapter 6 of the Service
Instructions
or
Hardware error of the Master
CPU in the RAM.
200 24V missing ---
300 - 399 Error in data transmission to the sewing motor Check cables
400 - 411 General stepping motor error ---
412 - 417 End stage error ---
418 - 423 Error of the stepping motor card when
transmitting the acknowledgement message
---
424 - 429 General stepping motor error ---
11.2 Error messages of the machine programme
If an error in the programme sequence occurs, the message
"
Error XXXXX
" will be displayed
Should an error occur, proceed as follows :
–
Note the error number.
–
Stop and start again the machine.
–
Repeat the process during which the error has happened.
–
Should the error occur again, note the description regarding the
error.
Note:
The error lists describes only the errors that can be eliminated. Should
any other errors occur, please contact the Dürkopp-Adler Service.
Error number Explanation Remedy
10504 Pressure loss. Open the compressed air stop
valve
or
the pressure of the main supply
line is too low.
10555 Transfer plate no longer available. Insert transfer plate or
regulate the inductive switch of the
transfer plate.
10017 Stepping motor end stage error, supply cable
defect etc.
Check supply cable or
suppress end stage error or
replace the end stage
(Only Service).
108
To Next Page
Loading...
