3.9.2 Checking oil level and oil supply
Rule and control
After long stops, the major part of the oil is in the lower oil container.
Therefore, the oil level should be checked after about 20 sewing
cycles.
–
Check oil level in oil container 1.
The oil level must stand between the marks MIN and MAX.
–
Should the oil level in the container 1 drop below the mark MIN
,check additionally also the oil level in the oil container 2.
When the oil level stands there above the mark MAX, do not yet
top up. Set about 20 further pockets and check the oil level once
more.
–
Fill the oil through the filling neck of the oil container 1.
–
Check the oil supply on the oil container 1.
A formation of bubbles must be visible.
Proceed to the control while the machine is running.
Caution: Danger of bodily injuries !
Turn off main switch.
Switch off the sewing machine before proceeding to any installation
work on the oil circulation system.
Oil can irritated the skin.
Avoid long skin contacts with the oil.
Wash thoroughly the contaminated skin.
ATTENTION !
The handling and the disposal of mineral oils is subject to statutory
regulations.
Deliver the used oil to an authorised oil reception centre.
Protect your environment.
Do not spill any oil.
2
1
62
To Next Page
Loading...
