4.6 Position of the two setting wheels
The position of the rear setting wheel 1 determines the "Folding
position" of the middle slide in its "rear section. The position of the
setting wheel required for the respective fabric type is indicated, as far
as it has been determined, on the sticker of the transfer plate.
The position of the front setting wheel 2 determines the "Folding
position" of the middle slide in its "front" section. The sticker on the
transfer plate indicates the position of the setting wheel, being
according to the experience made, the best for the fabric involved.
Caution: Danger of bodily injuries !
Do not introduce your hands into the area of the moving machine parts.
Rule and control
The position of the setting wheels 1 and 2 must be adapted to the
fabric thickness involved for obtaining the optimum folding results.
–
Select the "
Single step mode
" function.
–
Press the "
Start
" key as often as necessary.
Correction
–
Select the "
Single step mode
" function.
–
Repeat pressing the "
Start
" key until the slides can be shifted by
hand.
–
Push the slides inwards by hand.
It should be possible to shift the slides easily, but a resistance
should be felt when they are pushed inwards.
–
Reset the setting wheels 1 and 2 until an optimum folding result is
achieved.
–
The thicker is the fabric, the higher must be the values set.
1
2
82
To Next Page
Loading...
