DURKOPP ADLER 806 - Sewing Foot; General Information; Timing the Sewing Foot Movement

2.6 Sewing foot
2.6.1 General information
The adjustment of the upper and lower sewing foot travel position is
described under chapter 6.2.6 of the Operating Instructions.
2.6.2 Timing the sewing foot movement
Caution: Danger of bodily injuries !
The machine must be in the position "Safe motor stop ".
Rule and control
The sewing foot should start moving upwards at the moment of the
loop formation.
–
Lower the sewing head by the function "
Lifting/lowering the
sewing head
".
–
Press the key "
O
".
"Safe motor stop " will be switched on.
Correction
–
Loosen the two screws 1.
–
Turn the eccentric 2 on the shaft accordingly.
–
Tighten the screws 1.
1 2
23