DURKOPP ADLER 806 - Height of the Corner Introduction Slide

4.5.4 Height of the corner introduction slide
Caution: Danger of bodily injuries !
Do not introduce your hands into the area of the moving machine parts.
Rule and control
The distance between the entered corner introduction slide 2 and the
lateral slide sheet 3 should correspond to a middle fabric thickness.
–
Select the "
Single step mode
" function.
–
Press the "
Start
" key as often as required.
Correction
–
Loosen the screw 1.
–
Change the height of the corner introduction slide 3 accordingly.
–
Tighten the screw 1.
1 2 3
81