3.2 Sewing foot height / lower stroke position
Caution: Danger of bodily injuries !
The machine must be in the "Safe motor stop"
position.
Rule and control
–
Lower the sewing head by the function "
Lifting/lowering the
sewing head
".
–
Press the key "
O
".
"Safe motor stop" will be switched on.
–
Remove head cover.
–
Loosen wing screw 4 and set the setting wheel 5 to the lowest
value.
–
Move the sewing foot into its lowest position by turning the
handwheel.
–
The distance between the lower end of the oblong hole and the
bolt should amount to 1 mm.
Correction
–
Remove head cover.
–
Loosen screw 3.
–
Shift the block 1 so that the distance between the bolt 3 and the
lower end of the oblong hole amounts to 1 mm.
–
Retighten screw 3.
–
Replace head cover.
1
2
3
4
5
44
To Next Page
Loading...
