DURKOPP ADLER 806 - Page 99

Checking the position in respect to the lower sewing position
–
The transfer carriage travels to the lower sewing position.
–
Lower the transfer plate by the function "
Lowering/lifting the
transfer plate
".
–
Lower the sewing head by the function "
Lowering/lifting the
sewing head
".
–
The position of the transfer plate can be changed by the arrow
keys, but the position will not be memorised.
If the position does not suit, loosen the four screws 1 on both sides
of the transfer lever and adjust the transfer plate so that the needle
stitches into the lower hole.
ATTENTION !
Following a new adjustment of the transfer plate, balance also the
positions completely.
–
Press
RETURN
key.
The sewing head will be lifted.
The transfer plate will be lifted.
Balancing the position in respect to the folding station
–
The middle slide will advance.
The middle slide will be lowered.
The transfer carriage will travel to the folding station.
–
Lower the transfer plate by the function "
Lifting/lowering the
transfer plate
".
–
Adjust the transfer plate by the arrow keys of the control unit so
that the projection of the middle slide into the seam contour of the
transfer plate is equal at all sides.
The current co-ordinates will be displayed.
–
Lift and lower again the transfer plate by the function
"
Lifting/lowering the transfer plate
".
–
Check and correct, if required, the adjusted position.
–
Press
RETURN
key.
The transfer plate will be lifted.
The middle slide will return.
Checking the adjustments
–
Press the key "
F1
".
The balancing of positions will be repeated.
–
Check the adjusted positions of the transfer carriage.
–
After having checked the positions press the key "
F4
".
The balancing of positions will be closed.
1
99