Maintenance Manual (960-942) 4-42
Replacement Procedures
4.24.3 Installing the Wireless LAN antennas
To install the Wireless LAN antennas, follow the steps below.
1. Stick new Wireless LAN antennas (AUX/Main) in place.
Figure 4-50 Stick Wireless LAN antennas
2. Arrange the Wireless LAN antenna cables in place as shown in below
figure.
Figure 4-51 Arrange Wireless LAN antenna cables
4.24.4 Installing the Camera module
To install the camera module, follow the steps below and refer to Figure 4-
47 to Figure 4-52.
1. Peel off the protection sheet from a new camera module and stick the
new camera module to the LCD cover.
2. Stick two pieces of AL TAPE on the new camera module.
3. Stick two pieces of GASKET on the AL TAPE.
4. Connect the camera FPC to the connector on the camera module.
5. Peel off the separators on the camera FPC and stick the FPC to the
LCD cover in place.
Wireless LAN antenna (Main)
Wireless LAN antenna (AUX)
To Next Page
Loading...
