Maintenance Manual (960-942) 2-20
Troubleshooting Procedures
Check 6
System board may be faulty. Replace it with a new one following
the instructions in Chapter 4, Replacement Procedures.
2.12 Memory media (SD Card) Slot Troubleshooting
This section describes how to determine if the computer's Memory media
(microSD Card) functions are functioning properly. Perform the steps below
starting with Procedure 1 and continuing with the other procedures as
required.
Procedure 1: Check on Windows OS
Procedure 2: Connector Check and Replacement Check
2.12.1 Procedure 1 Check on Windows OS
Insert a microSD Card into the slot. Check if the installed Windows
recognizes automatically the microSD Card and the data in the microSD
Card can be read.
If the card is not recognized or data are not read, go to Procedure 2.
2.12.2 Procedure 2 Connector Check and Replacement Check
The Memory media (microSD Card) connection is shown in the following
figure.
As the connection may be defective, disassemble the computer and check
each connection.
If the problem still occurs, go to Check 1.
Check 1
Memory media (microSD Card) may be disconnected. Make
sure the Memory media is firmly inserted to IS2142. If not, insert
it firmly. If the it is still not functioning properly, perform Check 2.
Check 2
Memory media (microSD Card) may be faulty. Replace it with a
new one following the step in Chapter 4 Replacement
Procedures. If the problem continues, perform Check 3.
Check 3
System board may be faulty. Replace it with a new one following
the step in Chapter 4 Replacement Procedures.
<System board>
IS2142
microSD card
To Next Page
Loading...
Need help?
General
