dynabook PORTEGE X40-J Series - Page 93

Maintenance Manual (960-942) 4-20
Replacement Procedures
Figure 4-21 Installing the dual button unit/Click pad (1)
2. Set the Dual button to the Cover Assembly in place.
3. Set the Dual button FPC to the dual button plat and secure it with the
screws.
4. Set the Dual button plat to the Cover Assembly and secure it with the
screws.
5. Peel off the separator on the new Click Pad RIM ASSY and stick a new
Click pad to the Cover Assembly.
Figure 4-22 Installing the dual button unit/Click pad (2)
6. Stick a new GASKET TAPE CPAD and SQUARE CUSHION to the
Click pad and Click Pad RIM ASSY.
Click Pad RIM ASSY
Click Pad RIM ASSY
Click Pad RIM ASSY
For Click Pad without Fingerprint sensor, stick the Click Pad FACE SHEET
to the new Click Pad before use.
1
1
2