2 Installation
2.7 NET network
56 Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com
Fitting and removing the Net connection cable
▶ With easy800 standard you must first remove the cover plate.
Both RJ45 interfaces become visible.
▶ Plug in the cable; it must snap into the socket with an audible click .
▶ Before a cable is removed, the mechanical interlock must be undone ,
.
Prefabricated
The following easyNet connection cables are available for simple installation:
Table 2: Prefabricated cables, RJ45 plug on both ends
Figure 57:Plugging and unplugging a
cable easy800 standard
Figure 58:Plugging and unplugging a cable
easy806-DC-SWD
Cable length
Type designation
cm
30 EASY-NT-30
80
EASY-NT-80
150
EASY-NT-150
To Next Page
Loading...
