Menu structure of CI 3000
109
Version 2.09 09. April 2014
Activate/deactivate Superuser mode (release superuser rights)
With this input screen the input options lock can be released and setpoint values changed in the Superuser
mode.
The release of the lock is only to be carried out by service personnel!
With activated setpoint interlock (restricted setpoint changes) a password is necessary.
As a general rule: The lock is reactivated no later than 10 minutes after the last keystroke and the
switching on of the operator terminal.
Case A: Without setpoint interlock - without password request:
INTERLOCK Entry Default
Settings
Possible: √ √ = Cancel entry block to allow settings to be made
MODE and ↵ -
‐ Enter the current date in reverse order (not shown on display).
‐ Press the ENTER key (↵) to confirm, indicated by S displayed on the screen.
‐ After entering, exit the operating screen by pressing the ESC button.
Example: The current date is April 17, 2035, which in order of day-month-year is 17.04.35. In this instance the
entry required to grant Superuser rights is 534071.
Case B: With setpoint interlock - with password request:
With activated setpoint interlock (restricted setpoint changes) a password is necessary. The Supe
ruser password (6 to 7 characters) must be requested from the manufacturer in conjunction with the
specification of the CI 3000 serial number (see menu 7-2 or the rating plate). It only authorises ac
cess for the current and following day. Afterwards, a new password must be requested! After enter
ing the password, exit the operating screen by pressing the ESC button.
SETPOINT INTERLOCK
Release √
Password: XXXXXXX
√ = lock released
Superuser password entry.
To Next Page
Loading...