Menu structure of CI 3000
88
Version 2.09 09. April 2014
S Screen 6-1-6-2 Totalizer
Use the up and down cursor keys (↑) (↓) to scroll through the separate totalizers.
Page 1: Select totalizer, current display - page 1, with → button, scroll to page 2, with ← button, back.
Press ENTER to configure the totalizer.
SUMMING UNIT XY X: ! = alarm system primed (block lock input not active)
. = deprimed (block lock input active)
- = block lock (input not defined)
Y: √ (checkmark) = OK
X = activated
Name of totalizer Name and selection of the totalizer, i.e. its status.
Summ. power XXX.X Display
current capacity in [kW/h]* i.e.
current flow rate in l/h* i.e.
current gas flow rate in m3 /h*
*: depending on which measuring point is selected
Power limit XXX.X Display
Capacity limit in [kW/h] / flow rate limit in [l/h] / gas flow rate in m3/h
at which an alarm is activated, i.e. a message is sent.
Page 2: Select totalizer, current display - page 2, with ← button, back to page 1
(only shown when watersave is set to Y, see page 3)
Press ENTER to configure the totalizer.
SUMMING UNIT XY X: ! = alarm system primed (block lock input not active)
. = deprimed (block lock input active)
- = block lock (input not defined)
Y: √ (checkmark) = OK
X = activated
Name of totalizer Name and selection of the totalizer, i.e. its status.
Actual Val. XXX.X Display
current cumulative consumption in [kW]* i.e.
current cumulative flow rate volume in l* i.e.
current cumulative gas volume in m3 **
*: depending on which measuring point is selected
Max. Consum. XXX.X Display
Limit value for the consumption in [kW] / flow rate in [l] / gas volume in m3,
at which an alarm is activated, i.e. a message sent.
To Next Page
Loading...