Menu structure of CI 3000
89
Version 2.09 09. April 2014
Page 3: Configuration totalizer
Press ENTER to configure the totalizer.
SUMMING UNIT XY Entry Default
Name of totalizer Name and select totalizer (max. 19 characters)
A name should always be entered for the totalizer!
↑ ↓ number
Watersave X Watersave function ↑↓ (Y/N) N
Priority x Alarm priority ↑ ↓ (0 .. 2)
Meas. Points → Select associate measuring locations Continue to Screen 6-1-6-2-a
Power limit Limit value for the
consumption in [kW] / flow rate in [l] / gas volume in m3,
at which an alarm is activated, i.e. a message sent.
Only shown when watersave is set to N
↑ ↓ number 0.0
max. flow x.x Max. flow rate in l/h to be monitored
(when 0.0 is parameterised, then the function is
deactivated).
Only shown when watersave is set to Y
l/h 0.0
max. Consum. x.x Max. consumption to be monitored
(when 0.0 is parameterised, then the function is
deactivated).
Only shown when watersave is set to Y
l 0.0
Store close x Only to be monitored when the alarm is primed?
Only shown when watersave is set to Y
For configuration of the block lock see menu 6-1-3-1
Y/N N
.Module n
.Channel k
Digital output of the SIOX module and channel via
which the solenoid valve activates the watersave
Only shown when watersave is set to Y
↑ ↓ number
Idle Curren x Quiescent current input (Y): the solenoid valve is closed
voltage free
Operating current input (N): the solenoid valve is open
voltage free
Only shown when watersave is set to Y
↑ ↓ number J
Unlock Release/enable solenoid valve following activation. Only
functions when the store is open again, i.e. when the block
lock is deactivated.
By pushing the ENTER button the request screen appears
for the release command:
Are you sure?
No: ESC Yes: o
Only shown when watersave is set to Y
↵ ESC
Delete Delete totalizer:
Displays prompt: Are you sure? No: ESC Yes: ↵
↵ ESC
To Next Page
Loading...