Patient Monitor User Manual Monitoring ECG/ RESP
- 105 -
LEAD TYPE
Users can select either 3 LEADS or 5 LEADS for this item.
ECG DISPLAY: it varies according to LEAD TYPE.
When LEAD TYPE is set to 3 LEADS, ECG DISPLAY can be set to NORMAL DISPLAY, it
can display one ECG waveform on the main screen.
When LEAD TYPE is set to 5 LEADS, ECG DISPLAY can be set to NORMAL DISPLAY,
MULTI-LEADS DISPLAY and HALF-SCN MULTI-LEADS DISPLAY. Select NORMAL
DISPLAY to display two ECG waveforms on the main screen; Select MULTI-LEADS
DISPLAY to display seven ECG waveforms which occupying the area of seven waveforms on
the main screen; Select HALF-SCN MULTI-LEADS DISPLAY to display seven ECG
waveforms on the screen, occupying the area of four waveforms.
NOTE:
If 3 LEADS is selected in the ECG SETUP menu, only NORMAL DISPLAY can be
selected for ECG DISPLAY item in the sub-menu.
ST ANALYSE
Pick this item to access ST ANALYSE. Please refer to Section 13.6 ST Segment Monitoring
for details.
ARR ANALYSE
Pick this item to access ARR ANALYSE. Please refer to Chapter 13.7 Arr. Monitoring for
details.
OTHER SETUP
Pick this item to access OTHER SETUP as shown below:
Figure 13-8 Other Setup menu
Users can access the following functions:
SMART LEAD OFF: in 5 LEADS mode, if the CH1 and CH2 can not measure
To Next Page
Loading...
