Patient Monitor User Manual Installation of Monitor
- 13 -
2.3 Powering on the Monitor
After you power on the monitor, LOGO information will be displayed on the screen.
WARNING
If any sign of damage is detected, or the monitor displays some error messages, do not
use it on any patient. Contact biomedical engineer in the hospital or Customer Service
Center immediately.
NOTE:
1 Check all the functions of the monitor and make sure that the monitor is in good
status.
2 If rechargeable batteries are provided, charge them after using the device every time,
to ensure the electric power is enough.
3 After long-time continuous running, please restart the monitor to ensure the monitor’s
steady performance and long lifespan.
2.4 Connecting Patient Sensors
Connect all the necessary patient sensors between the monitor and the patient.
NOTE:
For information on correct connection, refer to related chapters.
2.5 Checking the Recorder
If your monitor is equipped with a recorder, open the recorder’s door to check if paper is properly
installed in the slot. If no paper exists, refer to Chapter 9 Recording for details.
To Next Page
Loading...
