EDAN M8 Series - 9.5 Recorder Alarm Information

Patient Monitor User Manual Recording (Optional)
- 76 -
 Insert a new roll of paper into the paper cassette, printing side facing upwards.
 Ensure proper position and tidy margin.
 Pull about 2cm of the paper out, and close the recorder casing.
NOTE:
Be careful when inserting papers. Avoid damaging the thermo-sensitive print head.
Unless when inserting papers or shooting troubles, do not leave the recorder catch open.
Removing Paper Jam
When the recorder functions or sounds improperly, you should open the recorder casing to check
for a paper jam. Removing the paper jam in the following way:
 Cut the record paper from the feeding edge.
 Open the recorder casing.
 Re-insert the paper.
NOTE:
If the monitor is not configured with the recorder function, it will indicate No Recorder
after the Record button is pressed.
9.5 Recorder Alarm Information
Technical Alarm:
Message
Cause
Alarm Level
What to do
Recorder Out Of
Paper
Recorder Out Of Paper
Low
Please install the paper.
No Recorder
The user presses the
RECORD button when
Recorder is not
configured.
Low
Notify the manufacturer’s
service staff to install and
set the recorder.