Patient Monitor User Manual Installation of Monitor
- 12 -
Chapter 2 Installation of Monitor
Installation should be carried out by qualified service personnel, either by the hospital’s
biomedical department, or by support of the manufacturer.
For mechanical and electrical installation, you need technically qualified personnel with
knowledge of English. Additionally, for monitor configuration, you need clinically qualified
personnel with knowledge of the use environment.
NOTE:
1 The monitor configuration settings must be configured by authorized hospital
personnel.
2 To ensure that the monitor works properly, please read Chapter 1 Intended Use and
Safety Guidance and follow the steps before using the monitor.
2.1 Opening the Package and Checking
Visually examine the package prior to unpacking. If any signs of mishandling or damage are
detected, contact the carrier to claim for damage. Open the package and take out the monitor and
accessories carefully. Keep the package for possible future transportation or storage. Check the
components according to the packing list.
Check for any mechanical damage.
Check all the functions, cables and accessories.
If there is any problem, contact the manufacturer or local representative immediately.
2.2 Connecting the Power Cable
Connection procedure of the AC power line:
Make sure the AC power supply complies with the following specifications: 100 V-240 V~,
50 Hz/60 Hz.
Connect the power cord provided with the monitor. Connect the power cord to connector of
the monitor. Connect the other end of the power cord to a grounded power outlet.
NOTE:
Connect the power line to the jack special for hospital usage.
Connect to the ground line if necessary. Refer to Section 1.2 Safety Guidance for details.
NOTE:
When the battery configuration is provided, after the device is transported or stored, the
battery must be charged. Powering on without connecting AC power supply may cause
the device to malfunction. Switching on AC power supply can charge the battery no
matter if the monitor is powered on.