EDAN M8 Series - Page 24

To Next Page

To Previous Page

Patient Monitor User Manual Introduction

- 15 -

Figure 3-1 iM8/M8 Patient Monitor

The monitor has 6 models: M8, M8A, M8B, iM8, iM8A and iM8B.

Figure 3-2 iM8/M8 Patient Monitor

②

③

⑥

Main Page

Default Chapter5
- Table of Contents5
Chapter 1 Intended Use and Safety Guidance10
- Intended Use/Indications for Use10
- Safety Guidance10
Chapter 2 Installation of Monitor21
- Opening the Package and Checking21
- Connecting the Power Cable21
- Powering on the Monitor22
- Connecting Patient Sensors22
- Checking the Recorder22
Chapter 3 Introduction23
- General Information23
- Screen Display26
- Button Functions30
- Interfaces31
- Built-In Rechargeable Battery33
Chapter 4 System Menu36
- Patient Setup37
- Default Setup38
- Mark Event39
- Face Select40
- Time Setup41
- Record Setup41
- Module Setup43
- Tracing Waveforms Selection43
- Monitor Version43
- Alarm Volume44
- Key Volume44
- Drug Calculation44
- Waveform Demonstration44
- Maintenance45
- Data Storing48
- Wireless Network with Router (Optional)51
Chapter 5 Face Select53
- Selecting Operating Screen53
- Standard Screen53
- Trend Screen53
- Oxycrg Screen54
- Large Font Screen54
Chapter 6 Alarms57
- Alarm Modes57
  - Alarm Level57
  - Alarm Setup59
- Alarm Cause61
- Audio Alarm Paused61
- Audio Alarm off62
- Alarm Reset62
- Parameter Alarm62
- When an Alarm Occurs63
- Testing Alarms63
Chapter 7 Alarm Information64
- Physiological Alarm Information64
- Technical Alarm Information68
- Prompts75
- Adjustable Range of Alarm Limits76
Chapter 8 Freeze79
- General79
- Entering/Exiting Freeze Status79
- FROZEN Menu79
- Reviewing Frozen Waveform80
Chapter 9 Recording (Optional)81
- General Information on Recording81
- Recording Type81
- Recording Startup83
- Recorder Operations and Status Messages84
- Recorder Alarm Information85
Chapter 10 Trend and Event86
- Trend Graph86
- Trend Table87
- NIBP Recall89
- Alarm Event Recall90
Chapter 11 Drug Calculation and Titration Table (Optional)92
- Drug Calculation92
- Titration Table94
Chapter 12 Maintenance/Cleaning96
- Inspecting96
- Maintenance Task and Test Schedule96
- Care and Cleaning97
- Replacement of Fuse103
- Cleaning Battery and Battery Compartment Cover103
Chapter 13 Monitoring ECG/RESP104
- Overview104
- ECG Safety Information104
- Monitoring Procedure106
  - Preparation106
  - Placing Electrodes for ECG Monitoring107
- ECG Screen Hot Keys111
- ECG Menu112
  - Ecg Setup112
- ST Segment Monitoring (Optional)116
- Arr. Monitoring (Optional)120
- Measuring RESP124
Chapter 14 Monitoring Spo129
- Overview129
- Spo Safety Information129
- Monitoring Procedure130
- Measurement Limitations131
- Assessing the Validity of a Spo Reading132
- Spo Alarm Delays132
- Perfusion Index (PI)133
- Spo SETUP133
Chapter 15 Monitoring NIBP135
- Overview135
- NIBP Safety Information135
- Measurement Limitations136
- Measurement Methods137
- Measurement Procedures137
- Nibp Setup140
- Resetting NIBP141
- Calibrating NIBP141
- Leak Test141
Chapter 16 Monitoring TEMP143
- TEMP Monitoring143
- Temp Setup143
Chapter 17 Monitoring IBP (Optional)145
- Introduction145
- IBP Safety Information145
- Monitoring Procedure146
- IBP Menu147
Chapter 18 Monitoring CO (Optional)154
- General154
- Monitoring Procedure155
- Co 2 Setup161
- Setting CO 2 Corrections164
Chapter 19 Accessories166
Chapter 20 Warranty and Service173
- Warranty173
- Contact Information173
Appendix I Specifications174
- A1.1 Classification174
- A1.2 Specifications174
Appendix II EMC Information192
- A2.1 Electromagnetic Emissions192
- A2.2 Electromagnetic Immunity192
- A2.3 Electromagnetic Immunity194
- A2.4 Recommended Separation Distances197
Appendix III Default Settings198
- A3.1 Patient Information Default Settings198
- A3.2 Alarm Default Settings198
- A3.3 ECG Default Settings198
- A3.4 Resp200
- A3.5 Spo200
- A3.6 Pr200
- A3.7 Nibp201
- A3.8 Temp201
- A3.9 Ibp201
- A3.10 Co202
Appendix IV Abbreviations203

EDAN M8 Series - Page 24

Table of Contents

Related product manuals