EDAN X8 - Page 59

Patient Monitor User Manual Alarm Information
- 46 -
Message
Cause
Key ARR Alarm Off
One of Key ARR alarms is set to Off.
Electrode Contact Poor
The electrode has bad contact with patient’s body.
SpO
2
Search Pulse
SpO
2
module is analyzing the patient signal and searching
for the pulse to compute the saturation, when sensor is
connected with patient.
Manual Measuring
In manual measuring mode
Continual Measuring
In continuous measuring mode
Auto Measuring
In automatic measuring mode
Measurem. Canceled
Press the “Start/stop NIBP measurement” button or shortcut
key to stop the measurement.
Calibrating
During calibrating
Calibrat. Canceled
Calibration is over.
Leak. Test Running
The leakage test is in process.
Leak.Test Canceled
Pneumatic test over
Module Self Test
The module is self-testing.
STAT Measuring
Block vessel to puncture in this mode.
Manometer Mode
Calibrate in this mode.
Please Switch To Maintain
Mode
Need to calibrate in this mode.
Please Switch To Normal
Mode
Need to measure in normal mode.
Leakage Test Ok
There is no leak.
Resetting
NIBP module in resetting
Please Start
NIBP module is in idle status.
Done
NIBP measurement is completed.
Be sure the cuff is disconnected
from monitor
In Cleaning Mode, the user clicks the Start Cleaning
button.
Cleaning succeeded
Cleaning finished successfully.
Cleaning failed
Abnormal air pressure in cleaning mode.
Cleaning in progress
The monitor is in cleaning progress.
Place Probe On Measure Place
Probe isn’t placed on the measurement site.
CO
2
Standby
Turn from measuring mode to standby mode, making the
module in energy-saving status.