C
HAPTER
38
| Multicast Filtering Commands
MLD Filtering and Throttling
– 1243 –
COMMAND MODE
Interface Configuration (Ethernet)
COMMAND USAGE
This command can be used to drop any query packets received on the
specified interface. If this switch is acting as a Querier, this prevents it from
being affected by messages received from another Querier.
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#ipv6 mld query-drop
Console(config-if)#
ipv6
multicast-data-drop
Use this command to enable multicast data guard mode on a port
interface. Use the no form of the command to disable multicast data
guard.
SYNTAX
[no] ipv6 multicast-data-drop
DEFAULT SETTING
Disabled
COMMAND MODE
Interface Configuration
EXAMPLE
Console(config)#interface ethernet 1/3
Console(config-if)#ipv6 multicast-data-drop
Console(config-if)#
show ipv6 mld filter This command displays the global and interface settings for MLD filtering.
SYNTAX
show ipv6 mld filter [interface interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
DEFAULT SETTING
None
To Next Page
Loading...
Need help?
General
