Edge EDGE-3270 - Page 5

iii
support@edgeovens.com Technical Support: +1 (724) 628 3050
PREFACE
Appliance is NOT to be cleaned with jets of water. End plugs and oven back are not to be
submerged.
NOTICE
NORTH AMERICA CUSTOMERS OVENS EQUIPPED WITH CASTERS:
When this appliance is installed with casters, it must be installed with the casters
supplied, a connector complying with ANSI Z21.69 (CSA 6.16), a quick-disconnect
device complying with ANSI Z21.41 (CSA 6.9), and a mechanism to limit movement of the
appliance without straining the connector or its associated piping system.
Adequate means must be provided to limit movement of the appliance without
depending on the connector, quick-disconnect device, or associated piping to limit
appliance movement.
The restraining device must be attached to the mounting eye located on the oven rear
side of the oven base assembly.
IMPORTANT
EXPORT CUSTOMERS OVENS EQUIPPED WITH CASTERS
When this appliance is installed with casters, it must be installed with the casters
supplied, a quick-disconnect device, and a mechanism to limit movement of the
appliance without straining the connector or its associated piping system.
Adequate means must be provided to limit movement of the appliance without
depending on the connector, quick-disconnect device, or associated piping to limit
appliance movement.
The restraining device must be attached to the mounting eye located on the oven rear
side of the oven base assembly.
IMPORTANT
To prevent damage to the oven and personal injury or death, the voltage, phase and
grounding of the electrical supply must be inspected and veried prior to energizing.
WARNING
NORTH AMERICA CUSTOMERS
This appliance is equipped with a three-prong (grounding) plug and must be connected
to a properly grounded three-prong receptacle. This is to protect you from a possible
shock hazard.
DO NOT remove the grounding prong from this plug or use any form of adapter to plug
the appliance into a standard two-prong receptacle.
Use only the cord set supplied by the oven OEM, or a direct replacement cord set
purchased from the oven OEM. Other cord sets may present a re and/or electric shock
hazard.
WARNING
WARNING AND SAFETY INFORMATION