Edimax IC-3110 - Page 102

CONFIGURING THE SURVEILLANCE SOFTWARE
INSTALLING THE 16-CHANNEL VIEWER SOFTWARE
able. You can add an Edimax Plug-n-View camera at a
remote site using PnV mode.
To add a network camera in PnV mode:
1. Click the Set Up button to show the configuration
menu.
2. Click Configure Cameras to show the configuration
screen.
3. Select a Channel from one to sixteen.
4. Select the Camera tab.
5. Click the Edimax PnV radio button to select PnV
mode.
6. In Edimax PnV, enter the following:
3-58