Edimax IC-3110 - Page 27

GETTING STARTED
INSTALLING THE CAMERA
6. There are two ways to power the device:
To use the 12V DC power adapter, plug the adapter into an electrical socket and connect the power cable into the power
jack located at the rear of the network camera.
To use an Ethernet cable, insert the Ethernet cable into a PoE
switch or PoE injector (IC-3110P only).
Note:
After installation, the LED flashes 10 to 15
seconds while connecting to the cloud.
The power LED stops flashing when con-
nected to the cloud. See Front View (page
1-2).
Ethernet Connector
2-4