Navigating the EV1000 Clinical Platform NI
5-10
Battery
The Pump-Unit is equipped with a battery to allow uninter-
rupted monitoring during power loss. Battery life is indicated
on the information bar by the symbols shown in Table 5-5.
For more information on the Pump-Unit battery, see“Pump-
Unit Communication and Power” on page 12-3.
Lock Screen
If the monitor is being cleaned or moved, lock the screen. For
cleaning instructions refer to “Cleaning the EV1000 Clinical
Platform NI” on page E-1. The screen will automatically
unlock once the internal timer has counted down.
1 Touch the lock screen icon.
2 Touch the time that the screen will remain locked on the
Screen Lock popup.
3 The information and status bar appear similar to the
following screen shot.
4 To unlock the screen, touch and hold the lock icon.
Status Bar
The status bar appears at the bottom of all active monitoring
screens. It displays faults, alarms, alerts, some warnings and
notifications. When there is more than one fault, alert or
alarm, the message is cycled every two seconds.
Table 5-5 Pump-Unit Battery Status
Battery
Symbol
Indication
The battery has greater than
50% charge remaining.
The battery has less than 50%
charge remaining.
The battery has less than 20%
charge remaining.
The battery is charging and
connected to mains power.
The battery is fully charged and
connected to mains power.
Battery information is
unavailable.
CAUTION
Pump-Unit includes a Lithium-Ion battery backup.
CAUTION
The system power status information, including battery
information, is only displayed on EV1000 Monitor when
the Pump-Unit is connected to the EV1000 Monitor with
the supplied Ethernet cable.
Figure 5-17 Lock Screen
Figure 5-18 Screen Locked
Figure 5-19 Status Bar
To Next Page
Loading...
