13-3
EV1000 Clinical Platform NI Accessories
EV1000 Pump-Unit Bracket
The EV1000 Pump-Unit bracket is intended for use with the
EV1000 Pump-Unit. The EV1000 Pump-Unit is supplied
with the Pump-Unit Bracket attached. If installation is
necessary, use all 4 screws provided to securely fasten the
bracket on to the back panel of the Pump-Unit, similar to the
EV1000 Monitor Bracket installation. Ensure that the Pump-
Unit and bracket are stable and secure prior to mounting the
post clamp to an IV Pole, post or approved roll stand.
Figure 13-7 EV1000 Pump-Unit Bracket
WARNING
Make sure the EV1000 Clinical Platform NI is securely
mounted, and that all cords and accessory cables are
appropriately arranged to minimize the risk of injury to
patients, users or the equipment. Refer to directions on
proper setup.
WARNING
Only use ClearSight Finger Cuffs, Heart Reference
Sensor and other EV1000 Noninvasive System
accessories, cables and or components that have been
supplied and labeled by Edwards. Using other
unlabeled accessories, cables and or components may
affect patient safety and measurement accuracy.
WARNING
The Pump-Unit must be positioned in an upright
position to ensure IP4X ingress protection.
To Next Page
Loading...
