Edwards EV1000

EV1000 Clinical Platform NI Advanced Features
14-3
Technology Selection
The EV1000 NI Databox Adaptor Cable enables clinicians to
monitor a patient’s hemodynamic parameters via a stream-
lined power supply configuration. The EV1000 Pump-Unit is
equipped with a battery backed power supply to allow
uninterrupted monitoring using both Platforms during power
loss. See Chapter 5: Battery on page 5-10 for information on
Pump-Unit battery status.

 EV1000 Databox
 EV1000 Monitor
 EV1000 Pump-Unit
 Ethernet Cable from Databox to Monitor
 Ethernet Cable from Pump-Unit to Monitor
 EV1000 NI Power Cable
 EV1000 NI Databox Adaptor Cable
 Mains Power Cable (Detachable Power Cord)
EV1000 NI Databox Adaptor Cable Connection
Refer to the schematic overview shown in Figure 14-4 for
cable connections. After the Monitor, Pump-Unit and
Databox are securely mounted, attach the Mains Power Cable
to the back panel of the Pump-Unit. Use the EV1000 NI
Power Cable and Databox Adaptor Cable to connect the
Pump-Unit to the Monitor and Databox. Use two Ethernet
Cables to connect the Pump-Unit with the Monitor and the
Databox with the Monitor.
If the EV1000 Databox fails turn on, when the EV1000 NI is
powered on, check the Databox Adapter cable connections.
If the problem persists, call Edwards Technical Support.
Do not use the EV1000 Power Adapter to power the Databox
in this configuration. Ensure the Databox is powered by the
same Pump-Unit powering the EV1000 Monitor.
Technology Selection Screen
The Technology Selection screen can be accessed by
touching the technology logo located at the center of the
information bar.
From this screen, the user can select from connected
monitoring technologies.
Non-Invasive Technology Button. The user
can select this button for non-invasive
hemodynamic monitoring using ClearSight
technology.
Minimally-Invasive Technology Button.
The user can select this button for minimally-
invasive hemodynamic monitoring using
FloTrac, VolumeView, or Oximetry technol-
ogies.
Figure 14-4 EV1000 NI Databox Adaptor
Cable Power Connections
WARNING
The EV1000 Clinical Platform NI meets the
requirements of IEC 60601-1:2005 for the system
configurations described in this manual. Connecting
external equipment or configuring the system in a way
not described in this manual may not meet this
standard.
CAUTION
The system power status information, including battery
information, is only displayed on EV1000 Monitor when
the Pump-Unit is connected to the EV1000 Monitor with
the supplied Ethernet cable.