Edwards EV1000

EV1000 Clinical Platform NI Accessories
13-2
EV1000 Monitor Bracket
The EV1000 monitor bracket is intended for use with the
EV1000 monitor. To install the monitor bracket to the rear
panel of the monitor, align the 4-hole mounting pattern in the
mounting bracket with the corresponding mounting pattern
on the back of the EV1000 monitor. Securely fasten the
bracket to the EV1000 monitor with the 4 screws provided
(see Figure 13-4) using a torque of 10 lb·in. Once the monitor
bracket is securely fastened to the EV1000 monitor, examine
the monitor's exterior for general physical condition. Make
sure the housing is not cracked, broken or dented.
EV1000 Monitor Types
EV1000 Monitor appearance and location of EV1000
Monitor cable connections shown throughout this operator’s
manual are for example only. Monitor appearance may vary
as seen in Figure 13-5. New Monitors (Advantech Model,
Figure 13-5, bottom row) have an additional cable cover and
the location of the power button is located on the rear of the
Monitor. Locations of cable connections may also vary
between Monitor types as shown in Figure 13-6
.
Figure 13-3 EV1000 Monitor Bracket
Figure 13-4 EV1000 Monitor and Monitor
Bracket
Figure 13-5 EV1000 Monitor Appearance and
Location of Power Button
Figure 13-6 EV1000 Monitor Cable
Connections
Cable Cover (detached)
Power Button