Chapter 12: Help and Troubleshooting
se the information in this chapter to determine the
cause and solution for error messages. This chapter
also describes the Graphical Steps Help Screens which
provide on screen instructions for device setup and
monitoring.
On Screen Help
The main help screen allows the user navigate to specific help
for ClearSight technology issues. Faults, alerts and warnings
notify the user of error conditions affecting parameter
measurements. Faults are technical alarm conditions that
suspend parameter measurement. The category help screen
provides specific assistance for faults, warnings, alerts,
troubleshooting, device setup and monitoring.
1 Touch the Settings button.
2 Touch Help to access the main help screen.
3 Touch the ClearSight button.
CO/SV, Oximetry, CVP and Thermodilution are not
applicable Category Help Screens while using noninvasive
ClearSight technology.
4 Touch the type of help needed: Faults, Warnings, Alerts,
Troubleshooting, Device Setup or Monitoring. The
problem type is listed at the top of the error message.
To silence the audible fault alert, touch the
Silence Alarm button. A new fault will generate a
new tone.
5 If Faults is selected, a new screen appears with a list of
faults.
6 Touch a fault from the list and touch Select to access
information for that fault. To view the full list of faults,
use the arrow buttons to move the selection highlight up
or down the list. The next screen displays the fault along
with possible causes and suggested actions. See
Figure 12-4, “Help Screen,” on page 12-2
Figure 12-1 Main Help Screen
Figure 12-2 Category Help Screen
Figure 12-3 Secondary Help Screen
To Next Page
Loading...
