3-5
Unpacking and Initial Setup
To turn off the Monitor:
1 Press the power button and wait until the status light on
the Monitor turns amber, indicating that the Monitor has
entered standby mode.
2 Disconnect Pump-Unit from AC mains.
NOTE: If the diagnostic tests detect an error condition, a
System Error Screen will replace the Startup screen. See
Chapter 12: Help and Troubleshooting or Appendix E:
System Care, Service and Support. Otherwise, call your
Edwards Lifesciences representative for assistance.
Select Language
The language selection screen appears after the software has
initialized and the self test is complete. Selecting the
language also sets the display units and the time and date
format to the default settings for that language (See Appendix
C: Monitor Settings and Defaults).
Each of the language-related settings can be changed later in
the Date / Time screen of the Monitor Settings Screen and in
the Language option of the General Monitor Settings Screen.
When the Language Selection Screen appears, touch the
desired language for use.
After the language is selected, the New Patient Screen
prompts you to enter a new patient.
Figures 3-2 and 3-3 are examples of Startup and
Language Selection screens.
Figure 3-3 Language Selection Screen
To Next Page
Loading...
