12-18 Probes and Biopsy
No Name Description
<5>
Specification of
guiding block˄13G˅
Matched with the corresponding biopsy needle˄13G˅
<6> Needle guide hole Used for installing the biopsy needle
<7>
Specification of angle
block˄60°˅
Corresponding to the size of the biopsy angle˄60°˅
NGB-016
No Name Description
<1>
Clamp of needle-guided
bracket
Used for installing the needle-guided bracket on the
transducer.
<2>
Groove of the needle-
guided bracket
Matches with the tab of the transducer.
<3> Angle adjusting base There are 3 types of angles available to be adjusted.
<4>
Angle shift sign (30°, 40°,
50°)
Matches with the biopsy angle
(30°, 40°, 50°).
<5> Angle pinch nut Used for fixing the angle lock at a chosen angle.
<6> Angle block
Determines the angle of the biopsy; different
specifications of blocks can be used.
<7> Guiding block
Used for installing the needles of different specifications,
5 types of needles are available.
<8>
Specification of guiding
block (14G)
Matched with the corresponding biopsy needle (14G).
<9>
Guiding hole of biopsy
needle
Used for installing the needles.
<10>
Pinch nut of needle-
guided bracket
Used for locking the needle-guided bracket and the
transducer.
12.2.3 Biopsy Preset
Open Biopsy page via [Setup]-> [System Preset]-> [Biopsy].
Bracket model
To set the default bracket for a probe.
(1) Select a probe model in the Probe Model list, all the supported bracket models will be
displayed in the !Bracket Model" list on the right side. (If the selected probe has no
bracket matched, no model is displayed.)
To Next Page
Loading...
