6-4 Display & Cine Review
z Press <Cine> or <Esc>, the images are still frozen but the system exits cine review.
6.2.2 Cine Review in 2D Mode
Manual cine review
After entering the cine review of 2D mode, rolling the trackball or rotating the
multifunctional knob will display the cine images on the screen one by one.
If you roll the trackball to the left, the review sequence is reversed to the image-storing
sequence, thus the images are displayed in descending order. Whereas, if you roll the
trackball to the right, the review sequence is the same as the image-storing sequence,
thus the images are displayed in ascending order. When the reviewing image reaches the
first or the last frame, further rolling the trackball will display the last or first frame.
The cine progress bar at the bottom of the screen (as shown in the figure below):
Auto Review
z Reviewing all
In the manual cine review, click [Auto Play] in the menu to activate auto cine review.
z Setting Region of Auto Review
You can set a segment of cine loop which can be reviewed automatically. After the auto
review region is set, the auto cine review can only be performed within this region; but the
manual cine review can be performed beyond this region. When the cine file is saved,
only the images within this region are saved.
a) Set first frame: Manually review the images until the frame which you want to set it
as start point, then click [Set First Frame] to set a start mark.
b) Set end frame: Manually review the images until the frame which you want to set it
as end point, then click [Set End Frame] to set an end mark.
c) Click [Auto Play] on the image mane.
d) Click [Auto Play] again or roll the trackball to enter manual review status; or press
<Cine> to exit cine reviewing.
e) Click [Skip to First]/ [Skip to Last] to review the first or last image.
Tips: you can perform cine review on each image window in the dual/ quad splitting
mode.
6.2.3 Cine Review in M Mode
After entering the cine review of M mode, rolling the trackball or rotating the multifunctional
knob will display the cine images on the screen one by one.
Roll the trackball to the left, the review progress slider moves to the left, the images moves to
the right, and the earlier stored images are invoked. Whereas, roll the trackball to the right,
the review progress slider moves to the right, and the images move to the left, the recently
stored images are invoked. When you review the images until the earliest or the latest frame,
further rolling the trackball will display the last or first frame.
The cine progress bar at the bottom of the screen (as shown in the figure below):
Start mark
Cursor
End mark
Current frame/ Total frames
To Next Page
Loading...
Need help?
General
