6-2 Display & Cine Review
2. Rotate <Depth/Zoom> knob to change the magnification factor among 0.8-10.
3. Exit:
z Press <Depth/Zoom>.
z Unfreeze the image, the system exit pan zooming status automatically.
6.1.2.3 iZoom (Full-screen Zooming)
Function: to magnify the image in full screen.
According to the region to be zoomed, the system supports two types of full-screen
zooming:
z Zoom in the standard area to full-screen, including image area, parameter area,
image banner, thumbnail area and so on.
z Zoom in the image area only to full-screen.
Procedures:
1. Set the User-defined key:
(1) Press <Setup> to enter [Setup] -> [System Preset] -> [Key Config].
(2) Select a function-free key in the function list.
(3) Select "iZoom" in the "Other" page.
(4) Click [OK] to complete the setting.
2. Open the image(or the under scanning image), press the user-defined iZoom key once to
zoom in the standard image area; and then press the key again to zoom in the image
area only.
3. Press the user-defined key again to return to normal status.
The iZoom status supports:
z Measurements, adding comments and body marks.
z Video output, saving image and printing the current area that is zoomed in.
z Exiting the zooming status by pressing <Probe>, <Patient>, <iStation>, <Review> or
<Setup>.
6.1.3 Freeze/ Unfreeze the Image
Press <Freeze> on the control panel to freeze a scanning image. In freeze mode, the probe
stops transmitting acoustic power, and all images as well as the parameters are kept still.
Tip: after freezing an image, the system may enter cine review, measure, comment adding, or
body mark mode, which is dependent upon preset. (Setting path: [Setup]ൺ[System Preset]ൺ
[Image Preset]ൺ"Freeze Config")
Press <Freeze> in freeze mode to unfreeze the image, the system continues image scanning.
6.1.3.1 Imaging Mode Switching When Frozen
Imaging mode switching in freeze mode follows the following principles:
z In splitting display B mode, press <B> to exit splitting display mode and display the
image of the currently activated window in full screen.
z In freeze mode, the system supports imaging mode switching between the sub-
modes (only for the activated window).
z The imaging mode and parameters of an unfrozen image is the same as the
corresponding one that before frozen; but the display format is the same as the one
before unfrozen.
To Next Page
Loading...
Need help?
General
