EIM TEC2000 - Table of Contents

i
Table of Contents
1Important Notes 1-1
1.1. Purpose..................................................................................................................................1-1
1.2. User Safety.............................................................................................................................1-1
2Quick Start 2-1
2.1. Set Position Limits...................................................................................................................2-1
2.2. Network Setup.........................................................................................................................2-5
2.3. Check Settings........................................................................................................................2-5
3Installation 3-1
3.1. Preparing the Stem Nut ............................................................................................................3-1
3.2. Mechanical Installation onto the Valve........................................................................................3-2
3.3. Electrical Connections..............................................................................................................3-2
3.3.1. Remove Separate Terminal Chamber (STC) Cover ..................................................................3-2
3.3.2. Sealing Cable/Conduit Entries ..............................................................................................3-3
3.3.3. Recommended Terminal Connections ...................................................................................3-3
3.3.4. Cable Connections ..............................................................................................................3-4
3.3.5. Replace Terminal Compartment Cover...................................................................................3-4
3.3.6. External Earth Ground Connections ......................................................................................3-4
3.4. Display Backup Module (DBM) – Optional..................................................................................3-5
3.5. Discrete Controlled Inputs.........................................................................................................3-6
3.6. Auxiliary Control Module (ACM) – Optional.................................................................................3-6
3.6.1. Wiring the ACM ..................................................................................................................3-7
3.6.2. Analog Controlled – Power Supply Connections ...................................................................3-10
3.6.3. External Variable Frequency Drive Wiring............................................................................ 3-13
3.6.4. Network Controlled............................................................................................................ 3-14
3.7. Auxiliary Relay Module (ARM) Wiring ......................................................................................3-15
3.8. Remote Display Module (RDM) Connection to the Actuator – Optional........................................3-16
3.8.1. 24Vdc Power Source.........................................................................................................3-17
3.8.2. 115/230Vac Power Source.................................................................................................3-17
3.8.3. Two RDMs (one 24Vdc and one 115/208/220/230 Vac power source)....................................3-18
4Operation 4-1
4.1. Local Display Module (LDM) .....................................................................................................4-1
4.1.1. Graphics Display and Message Center..................................................................................4-2
4.1.2. Control Knob and Selector Knob...........................................................................................4-2
4.1.3. LEDs .................................................................................................................................4-3
4.1.4. Normal Display Function......................................................................................................4-3
4.1.5. Multi-Port Valve Status Display Functions .............................................................................4-5
4.2. Remote Display Module (RDM) .................................................................................................4-5
4.2.1. RDM Operation with LDM.....................................................................................................4-5
4.3. Infrared Controller (IRC) – “Clicker”.............................................................................................4-6
4.4. Initializing the Actuator.............................................................................................................4-7
4.4.1. Setting Position Limits.........................................................................................................4-7