EasyManuals Logo

EIM TEC2000 User Manual

EIM TEC2000
85 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
5. Customizing Actuator Settings
TEC 2000 Installation & Operation Manual E2K-405-0902
5-16
Table 5-2 Relay Outputs #1 through #5 Configuration
Relay Default
Function
Configurable
Function
Configure
N.O./N.C.
Default
Setting
Configure
Flashing
RO#1 LSO
Valve full OPEN
See Table 5-3
Relay Output
Function List
Yes N.O. Yes
RO#2 LSC
Valve full
CLOSE
See Table 5-3
Relay Output
Function List
Yes N.O. Yes
RO#3 LSA
Intermediate
limit in closing
direction
See Table 5-3
Relay Output
Function List
Yes N.O. Yes
RO#4 LSB
Intermediate
limit in opening
direction
See Table 5-3
Relay Output
Function List
Yes N.O. Yes
RO#5 Monitor
Valve not
available
Generic see
NOTE
No 1 N.O.
and
1 N.C.
Yes
NOTE: Generic means the control of this relay has been given to the network if a Controlinc
card has been installed. The relay will not function if the Controlinc card is not installed.
Flashing means the output will cycle ON and OFF in one second intervals while the function
is active.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the EIM TEC2000 and is the answer not in the manual?

EIM TEC2000 Specifications

General IconGeneral
BrandEIM
ModelTEC2000
CategoryController
LanguageEnglish

Related product manuals