14 – 5
Section 14 • Maintenance Screen
MicroVission Controller • Operation and Service Manual • Emerson • 35391MV 1.3
Custom Task
The operator can record custom maintenance tasks not
listed on the Inspection/Maintenance column in the
“Chart” tab. Refer to Figure 14-8.
The Custom Maintenance Task pop-up appears when
the Custom Task button is clicked. The Operator can
then enter a description for the task performed on the
entry box, and click “OK” to save it and add it to the
Maintenance Log.
Figure 14-8. Maintenance Screen – Custom Maintenance Task Pop-up
The “Cancel” button will close the Custom Maintenance
Task pop-up.
To Next Page
Loading...
