Endress+Hauser Proline Promag W 400 - Reading Measured Values

Proline Promag W 400 EtherNet/IP Operation
Endress+Hauser 101
Function scope of "Locking status" parameter
Options Description
None The access status displayed in "Access status display" parameter applies →  62.
Only appears on local display.
Hardware locked The DIP switch for hardware locking is activated on the main electronics module.
This locks write access to the parameters .
Temporarily locked Write access to the parameters is temporarily lock due to device-internal
processing (e.g. data upload/download, reset). Once the internal processing has
been completed, the parameters can be changed once again.
11.3 Adjusting the operating language
Information →  75
For information on the operating languages supported by the measuring device
→  158
11.4 Configuring the display
• Basic settings for local display →  83
• Advanced settings for local display →  91
11.5 Reading measured values
With the Measured values submenu, it is possible to read all the measured values.
11.5.1 Process variables
The Process variables submenu contains all the parameters needed to display the current
measured values for every process variable.
Navigation
"Diagnostics" menu → Measured values → Process variables
‣
Process variables
Volume flow
Mass flow
Conductivity
Parameter overview with brief description
Parameter Description User interface
Volume flow Displays the volume flow currently measured. Signed floating-point number
Mass flow Displays the mass flow currently calculated. Signed floating-point number
Conductivity Displays the corrected volume flow currently calculated. Signed floating-point number