Endress+Hauser Proline Promag W 400 - Power Supply Requirements

Technical data Proline Promag W 400 EtherNet/IP
134 Endress+Hauser
Configurable Input Assembly • Volume flow
• Mass flow
• Electronic temperature
• Conductivity
• Totalizer 1 to 3
• Flow velocity
• Volume flow unit
• Mass flow unit
• Temperature unit
• Conductivity unit
• Unit totalizer 1-3
• Flow velocity unit
• Verification result
• Verification status

The range of options increases if the measuring device has one or
more application packages.
Fix Output
Output Assembly • Activation of reset totalizers 1-3
• Activation of reference density compensation
• Reset totalizers 1-3
• External density
• Density unit
• Activation verification
• Start verification
Configuration
Configuration Assembly Only the most common configurations are listed below.
• Software write protection
• Mass flow unit
• Mass unit
• Volume flow unit
• Volume unit
• Density unit
• Conductivity
• Temperature unit
• Totalizer 1-3:
– Assignment
– Unit
– Operating mode
– Failure mode
• Alarm delay
16.5 Power supply
Terminal assignment →  38
Pin assignment, device plug
→  39
Supply voltage Transmitter
Order code for "Power supply" Terminal voltage Frequency range
Option L
AC100 to 240 V 50/ 60 Hz, ±4 Hz
AC/DC24 V 50/ 60 Hz, ±4 Hz
Power consumption
Order code for "Output" Maximum power consumption
Option N: EtherNet/IP 30 VA/8 W